← All parts
Metro M7 Microsd
Adafruiti.MX RT1011
The Adafruit Metro M7 is a microcontroller board featuring an ARM Cortex M7 processor running at 500 MHz, with 128KB of SRAM and 8MB of QSPI flash. It supports CircuitPython and has various I/O pins including GPIO, ADC, PWM, I2C, SPI, and UART.
In stock
Specifications
6- Operating Voltage
- 6-12VDC (barrel jack) or USB type C (500mA peak from USB, ~800mA peak from DC) V
- Logic Level
- 3.3V V
- Clock Speed
- 500 MHz MHz
- Flash
- 8MB QSPI XIP Flash B
- Ram
- 128KB SRAM B
- Gpio Count
- 13 (D0 - D13) pins
Pinout
11Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| 3.3V | 3.3V | POWER | 3.3V regulator output |
| 5V | 5V | POWER | 5V regulator output when DC jack is used, or from USB |
| GND | GND | GND | Common ground for all power and logic |
| VIN | VIN | POWER | Higher of DC jack or USB voltage |
| D0 / RX | TX | UART | Transmit (output) pin for UART |
| D1 / TX | RX | UART | Receive (input) pin for UART |
| D2 - D13 | GPIO | GPIO | General purpose GPIO pins, with D13 connected to the red LED marked D13 next to the reset button |
| SDA | SDA | I2C | I2C data pin with 10K pull-up to 3V |
| SCL | SCL | I2C | I2C clock pin with 10K pull-up to 3V |
| A0 - A5 | GPIO | ADCPWM | Analog inputs and digital I/O pins, some capable of PWM |
| SCK / MOSI / MISO | SPI | SPI | Hardware SPI pins connected to the 2x3 header on the right hand side |
Interactive pinout
Highlight:
i.MX RT1011
Click a pin to copy its name · tap a tag above to spotlight a bus.