← All parts
Metro M7 With Airlift
Adafruiti.MX RT1011
Metro M7 with AirLift is a microcontroller board powered by the NXP i.MX RT1011 ARM Cortex M7 processor running at 500 MHz, featuring 4MB of QSPI flash and 128KB of SRAM.
In stock
Specifications
6- Operating Voltage
- 6-12VDC (barrel jack) or USB type C (5V)
- Logic Level
- 3.3V
- Clock Speed
- 500 MHz
- Flash
- 4MB QSPI XIP Flash
- Ram
- 128KB SRAM
- Gpio Count
- 13 (D0-D13)
Pinout
13| Pin | Name | Functions | Notes |
|---|---|---|---|
| 3.3V | 3.3V | POWER | Output from the 3.3V regulator |
| 5V | 5V | POWER | Output from the 5V regulator (when DC jack is used), or from USB |
| GND | GND | GND | Common ground for all power and logic |
| VIN | VIN | POWER | Higher of the DC jack or USB voltage |
| D0 / RX | RX | GPIOUART | Shared with ESP32 RX, used for UART receive (input) |
| D1 / TX | TX | GPIOUART | Shared with ESP32 TX, used for UART transmit (output) |
| D2 - D12 | GPIO | GPIO | General purpose GPIO pins |
| D13 | LED | GPIO | Connected to the red LED marked D13 next to the reset button |
| SDA | SDA | I2C | I2C data pin with 10K pull-up to 3V |
| SCL | SCL | I2C | I2C clock pin with 10K pull-up to 3V |
| MOSI | MOSI | SPI | Hardware SPI pin used for SPI connectivity, not GPIO |
| MISO | MISO | SPI | Hardware SPI pin used for SPI connectivity, not GPIO |
| SCK | SCK | SPI | Hardware SPI pin used for SPI connectivity, not GPIO |
Interactive pinout
Highlight:
i.MX RT1011
Click a pin to copy its name · tap a tag above to spotlight a bus.