← All parts
Sensorlab Gyroscope Calibration
AdafruitATmega328 or better
A board designed for gyroscope calibration using Adafruit SensorLab.
In stock
Specifications
2- Operating Voltage
- 3.3V or 5V (depending on the sensor)
- Logic Level
- 3.3V or 5V
Pinout
4Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| VCC | POWER | — | Power supply |
| GND | GND | — | Ground |
| SDA | I2C | I2C | |
| SCL | I2C | I2C |
Interactive pinout
Highlight:
ATmega328 or better
Click a pin to copy its name · tap a tag above to spotlight a bus.