← All parts
Sensorlab Magnetometer Calibration
AdafruitATmega328 or better
A development board for magnetometer calibration using Adafruit SensorLab and various software tools.
In stock
Specifications
2- Operating Voltage
- 3.3-5V (VCC) / 0-3.6V (GND) / I2C: 1.8-5.5V (SDA/SCL)
- Logic Level
- TTL/CMOS
Pinout
5Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| 3 | VCC | POWER | 3.3-5V |
| 4 | GND | GND | Ground |
| 6 | SCL | I2C | |
| 9 | SDA | I2C | |
| 14 | GPIO | — |
Interactive pinout
Highlight:
ATmega328 or better
Click a pin to copy its name · tap a tag above to spotlight a bus.