← All parts
Wiz5500 Ethernet Co Processor Breakout Board
AdafruitWIZ5500
A breakout board for the WIZ5500 Ethernet Co-Processor, supporting SPI and Ethernet connectivity.
In stock
Specifications
2- Operating Voltage
- 3.3V or 5V logic level dependent
- Gpio Count
- 7
Pinout
9Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| VIN | VIN | POWER | 3.3V or 5V logic level dependent |
| 3.3V | 3.3V | GND | 3.3V output from voltage regulator, up to 100mA |
| GND | GND | GND | Common ground for power and logic |
| SCK | SCK | SPI | SPI clock input pin |
| MISO | MISO | SPI | SPI MISO (Microcontroller In / Serial Out) pin |
| MOSI | MOSI | SPI | SPI MOSI (Microcontroller Out / Serial In) pin |
| CS | CS | SPI | SPI chip select pin |
| RST | RST | GPIO | Reset pin for the breakout board |
| IRQ | IRQ | GPIO | Interrupt pin, default state is active low |
Interactive pinout
Highlight:
WIZ5500
Click a pin to copy its name · tap a tag above to spotlight a bus.