← All parts
Ble Cat Thermal Printer With Memento
AdafruitESP32-S3
A development board for printing images with a BLE cat thermal printer using the MEMENTO camera module.
In stock
Specifications
3- Operating Voltage
- 3.7V (Lithium Ion Polymer Battery) - 4.2V (Charging) - 3.7V (Discharging) V
- Flash
- Not explicitly stated N/A
- Ram
- Not explicitly stated N/A
Pinout
6Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| 1 | GPIO0 | GPIO | Reset pin |
| 2 | GPIO2 | GPIO | Not used in this context |
| 3 | GPIO3 | GPIO | Not used in this context |
| 6 | GPIO6 | GPIO | Not used in this context |
| 12 | GPIO12 | GPIO | Not used in this context |
| 13 | GPIO13 | GPIO | Not used in this context |
Interactive pinout
Highlight:
ESP32-S3
Click a pin to copy its name · tap a tag above to spotlight a bus.