← All parts
Diy 8X2 Lcd Shield
Adafruit
A shield for an 8x2 LCD with wiring instructions using Arduino pins.
In stock
Specifications
3- Lcd Type
- 16x2 Parallel LCD (4-bit interface)
- Power Supply
- +5V
- Ground
- GND
Pinout
11Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| 1 | D7 | GPIO | LCD D4 |
| 2 | D6 | GPIO | LCD D5 |
| 3 | D5 | GPIO | LCD D6 |
| 4 | D4 | GPIO | LCD D7 |
| 9 | RS | GPIO | LCD RS |
| 10 | EN | GPIO | LCD EN |
| 5 | R/W | GND | LCD R/W, grounded for writing |
| 12 | DB4 | GPIO | LCD DB4 |
| 11 | DB5 | GPIO | LCD DB5 |
| 7 | DB6 | GPIO | LCD DB6 |
| 8 | DB7 | GPIO | LCD DB7 |
Interactive pinout
Highlight:
BOARD
Click a pin to copy its name · tap a tag above to spotlight a bus.