← All parts
Adafruit FXOS8700 Accel/Mag
Adafruit
The Adafruit FXOS8700 Accel/Mag breakout board combines an accelerometer and magnetometer with a gyroscope for motion sensing. It supports I2C communication and can be used with Arduino or CircuitPython.
In stock
Specifications
6- Operating Voltage
- 2-3.6V for both sensors
- Logic Level
- 3-5V I2C communication
- Gpio Count
- scl, sda, rst, ai1, ai2, gi1, g12
- Dimensions
- Not specified in the datasheet/guide text
- Connectivity
- I2C, 3.3V/5V compatible
- Usb
- Not specified in the datasheet/guide text
Pinout
8Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| VIN | Vin | POWER | 3.3-5V input, feeds the on-board 3.3V regulator |
| 3Vo | 3Vo | POWER | Output of the 3.3V linear regulator, can be used as an additional 3.3V supply on a 5V system |
| GND | Gnd | GND | Connect to GND on your development board |
| SCL | Scl | I2C | Level-shifted and 3-5V logic safe, connect to SCL on your development board |
| SDA | Sda | I2C | Level-shifted and 3-5V logic safe, connect to SDA on your development board |
| RST | Reset | GPIO | Optionally connect to RST or a GPIO pin for manual reset of the sensors |
| AI1, AI2 | Interrupts (Accel/Mag) | GPIO | Outputs only, not level-shifted, can be used with 3 or 5V logic systems |
| GI1, G12 | Interrupts (Gyro) | GPIO | Outputs only, not level-shifted, can be used with 3 or 5V logic systems |
Interactive pinout
Highlight:
BOARD
Click a pin to copy its name · tap a tag above to spotlight a bus.