← All parts
Lps35Hw Water Resistant Pressure Sensor
Adafruit
The LPS35Hw is a water-resistant pressure sensor with I2C and SPI interfaces for use in wet environments.
In stock
Specifications
9- Operating Voltage
- 3.0V - 5.0V
- Logic Level
- 3-5V
- Clock Speed
- Not specified
- Flash
- N/A
- Ram
- N/A
- Gpio Count
- 8
- Dimensions
- Not specified
- Connectivity
- I2C, SPI
- Usb
- N/A
Pinout
8| Pin | Name | Functions | Notes |
|---|---|---|---|
| Vin | Power | POWER | Input voltage, regulated to 3.3V if input is between 3-5V. |
| 3Vo | 3.3V Output | GND | Output of the on-board 3.3V regulator, up to 100mA available. |
| GND | Ground | GND | Common ground for power and logic. |
| SCK | I2C Clock | I2C | Connect to microcontroller's I2C clock line. |
| SDA | I2C Data | I2C | Connect to microcontroller's I2C data line. |
| CS | Chip Select | SPI | Used for SPI transactions, drop low to start an SPI transaction. |
| SDO | Serial Data Out | SPI | For data sent from the LPS35HW to your processor in SPI mode. |
| SDI | Serial Data In | SPI | For data sent from your processor to the LPS35HW in SPI mode. |
Interactive pinout
Highlight:
BOARD
Click a pin to copy its name · tap a tag above to spotlight a bus.