← All parts
Minipov4 Diy Full Color Persistence Of Vision Light Painting Kit
AdafruitAtmega328P-PU
A DIY full-color persistence of vision light painting kit with an Atmega328P-PU microcontroller, RGB LEDs, and USB programmability.
In stock
Specifications
4- Operating Voltage
- 3.6V (Zener diodes) to 5V (USB) via voltage regulator on board.
- Flash
- Not specified
- Ram
- Not specified
- Gpio Count
- Pins 0-1, A4-A5 are used for specific functions; other pins are GPIO.
Pinout
4Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| 0 | RX | UART | Serial UART rx |
| 1 | TX | UART | Serial UART tx |
| A4 | SDA | I2C | Analog pin A4 used for I2C |
| A5 | SCL | I2C | Analog pin A5 used for I2C |
Interactive pinout
Highlight:
Atmega328P-PU
Click a pin to copy its name · tap a tag above to spotlight a bus.