← All parts
Xbee Radios
Adafruit
An Adafruit XBee Radios adapter board with breakout pins for various XBee modules, including power and communication interfaces.
In stock
Specifications
3- Operating Voltage
- 3.3V - 6V
- Logic Level
- 3.3V
- Gpio Count
- 2 (DTR, RST)
Pinout
8| Pin | Name | Functions | Notes |
|---|---|---|---|
| 3V | power_input | POWER | This pin is either an input power pin (if 5V is not provided) or an output from the 250mA regulator if 5V is provided. |
| DTR | dtr | GPIO | Data terminal ready, a flow control pin used to tell the XBee that the microcontroller or computer host is ready to communicate. |
| RST | reset | GPIO | This pin can be used to reset the XBee. By default it is pulled high by the 10K resistor under the module. To reset, pull this pin low. |
| GND | ground | GND | Common ground for power and signal |
| CTS | cts | GPIO | Clear to Send, a flow control pin that can be used to determine if there is data in the XBee input buffer ready to be read. |
| 5V | power_input | POWER | This is the power input pin into the 3.3V regulator. Provide up to 6V that will be linearly converted into 3.3V. |
| RX | rx | UART | This is the XBee's serial receive pin. Serial data is sent on this pin into the XBee to be transmitted wirelessly. |
| TX | tx | UART | This it the XBee's serial transmit pin. Serial data |
Interactive pinout
Highlight:
BOARD
Click a pin to copy its name · tap a tag above to spotlight a bus.