← All parts
10-Bit 360 ns A/D Converter with Input Multiplexer and Sample/Hold
10-Bit 360 ns A/D Converter with Input M
ic
The ADC10662/ADC10664 are 10-bit A/D converters with built-in sample-and-hold and multiplexer, designed for high-speed conversions up to 1.5 MHz.
In stock
Specifications
9- Conversion Time
- 360 ns (typical)
- Max Sampling Rate
- 1.5 MHz (min)
- Low Power Consumption
- 235 mW (max)
- Total Harmonic Distortion
- -60 dB (max) (50 kHz)
- Resolution
- 10 Bits
- Range
- ±(VREF+ - VREF-)
- Accuracy
- ±1.5 LSB (max)
- Temperature Range
- -40˚C ≤TA ≤+85˚C
- Package
- M24B Small Outline, M28B Small Outline Tape & Reel
Pinout
13| Pin | Name | Functions | Notes |
|---|---|---|---|
| DVCC | Digital positive supply voltage input | POWER | Connects both DVCC and AVCC to the same voltage source, but bypass separately. |
| AVCC | Analog positive supply voltage input | POWER | Connects both DVCC and AVCC to the same voltage source, but bypass separately. |
| INT | Active low interrupt output | GPIO | |
| S/H | Sample/Hold control input | GPIO | Initiates a new conversion when forced low with CS low. |
| RD | Active low Read control input | GPIO | Enables data readout from output registers. |
| CS | Active low Chip Select control input | GPIO | Enables S/H and RD pins. |
| S0, S1 | Input channel select pins | GPIO | Selects the analog input during conversion based on state when S/H transitions low. |
| VREF− | Reference voltage negative input | POWER | |
| VREF+ | Reference voltage positive input | POWER | |
| VIN0, VIN1, VIN2, VIN3 | Analog input pins | ADC | Impedance should be less than 500Ω for best accuracy and speed. |
| GND, AGND, DGND | Ground pins | GND | Separate analog and digital grounds for bypassing. |
| DB0–DB9 | TRI-STATE output pins | GPIO | |
| SPEEDADJ | Speed adjustment pin | GPIO | Reduces conversion time with a connected resistor. |
Interactive pinout
Highlight:
10-Bit 360 ns A/D Converter with Input M
Click a pin to copy its name · tap a tag above to spotlight a bus.