Interface & Display IC

PCF8575 · Texas Instruments

The PCF8575 is a 16-bit quasi-bidirectional I/O expander for the I2C bus. It adds two 8-bit ports with latched, high-current outputs for directly driving LEDs, an open-drain interrupt output, and three hardware address pins for up to eight devices.

PCM5102A · Texas Instruments

The PCM5102A is a 112dB stereo audio DAC with an integrated PLL and DirectPath charge-pump line driver. It accepts 16-, 24-, and 32-bit PCM data over an I2S interface up to 384kHz.

SK6812 · Worldsemi

The SK6812 is an intelligent RGB LED with an integrated control IC in a 5050 package. Each pixel uses a single-wire data protocol with built-in constant-current drive and can be cascaded for addressable strings.

SN65HVD1050 · Texas Instruments

The SN65HVD1050 is a CAN transceiver designed for harsh environments, providing differential transmit and receive capabilities up to 1 Mbps.

SN65HVD230 · Texas Instruments

The SN65HVD230 is a 3.3V CAN bus transceiver compliant with ISO 11898-2. It supports data rates up to 1 Mbps, adjustable driver slope control, and a low-current standby mode for robust industrial networks.

SN65HVD231 · Texas Instruments

The SN65HVD231 is a CAN transceiver that operates with a single 3.3V supply and supports high-speed data rates up to 1 Mbps, featuring low power modes for reduced consumption.

SN65HVD232 · Texas Instruments

The SN65HVD232 is a CAN transceiver designed for operation in harsh environments, featuring robust protection and wide common mode range. It operates with a single 3.3V supply and supports data rates up to 1 Mbps.

SN65HVD72 · Texas Instruments

The SN65HVD72 is a RS-485 transceiver with robust ESD protection and operates from a 3.3-V supply in industrial temperature ranges.

SN65HVD75 · Texas Instruments

The SN65HVD75 is a RS-485 transceiver with robust ESD protection and operates in an industrial temperature range. It supports signaling rates up to 20 Mbps.

SN75176B · Texas Instruments

SN75176B is an RS-485 transceiver designed for bidirectional data communication on multipoint bus transmission lines, operating from a single 5V supply.

SN75179 · Texas Instruments

The SN75179 RS-485 Transceiver is a differential driver and receiver pair designed for balanced transmission-line applications, operating from a single 5V supply with input sensitivity of ±200mV.

SSD1306 · Solomon Systech

The SSD1306 is a single-chip OLED/PLED driver and controller for 128x64 dot matrix displays. It features an embedded display RAM, contrast control, and supports multiple MCU interfaces including 6800/8080 parallel, 3/4-wire SPI, and I2C.

TCA6408A · Texas Instruments

The TCA6408A is an I2C and SMBus expander with 8-bit parallel I/O, providing GPIO expansion for low-voltage systems.

TCA9534 · Texas Instruments

The TCA9534 is an I2C/SMBus expander with 8 general-purpose I/O ports and interrupt output, operating from 1.65V to 5.5V.

TCA9534A · Texas Instruments

The TCA9534A is an I2C/SMBus expander with 8 general-purpose parallel input/output (GPIO) ports, interrupt output, and configurable hardware addresses.

TCA9535 · Texas Instruments

TCA9535 is a 16-bit I2C expander with GPIO and interrupt capabilities, designed for parallel input/output expansion on the I2C bus.

TCA9548A · Texas Instruments

The TCA9548A is a low-voltage 1-to-8 bidirectional I2C switch that fans an upstream bus out to eight selectable channels. It resolves target address conflicts and supports voltage-level translation between 1.8V and 5V buses.

TCAN332 · Texas Instruments

The TCAN332 is a CAN transceiver designed for high-speed CAN networks with up to 5 Mbps data rates, operating on a single 3.3V supply.

TLC5940 · Texas Instruments

The TLC5940 is a 16-channel LED driver with grayscale PWM control and dot correction, providing constant current output for LEDs.

TLC59711 · Texas Instruments

The TLC59711 is a 12-channel LED driver with adjustable current outputs and a built-in linear regulator, designed for RGB LED control.

TPIC6B595 · Texas Instruments

The TPIC6B595 is a monolithic, high-voltage power shift register designed for driving relays and solenoids with up to 150mA per output.

TPL0401 · Texas Instruments

TPL0401 is a single-channel, 128-position digital potentiometer with an I2C interface, used for setting voltage references and trimming components.

TXB0104 · Texas Instruments

The TXB0104 is a 4-bit bidirectional voltage-level translator with automatic direction sensing. It shifts signals between a 1.2-3.6V A port and a 1.65-5.5V B port for push-pull interfaces.

TXB0106 · Texas Instruments

The TXB0106 is a bidirectional level-shifting and voltage translator with auto-direction sensing, designed for low-voltage translation between different supply rails.