← All parts
Esp32 S2 Reverse Tft Feather
AdafruitESP32-S2
A development board featuring an ESP32-S2 WiFi module, a color 1.14" IPS TFT display, and three tactile buttons.
In stock
Specifications
5- Operating Voltage
- 3.3V to 5V (USB) or 2.7V to 4.1V (LiPoly) via USB-C or JST PH connector.
- Flash
- 4MB MB
- Ram
- 2MB PSRAM MB
- Dimensions
- Not explicitly stated, but the Feather form factor is typically small.
- Connectivity
- USB-C for power and programming, JST PH connector for LiPoly battery
Pinout
12Low source legibility.The original manufacturer datasheet for this part was difficult to read, so this pinout may be incomplete or imperfect. Always confirm against the specific manufacturer’s datasheet before wiring.
| Pin | Name | Functions | Notes |
|---|---|---|---|
| D0 | D0 / GPIO0 | GPIO | Pushbutton |
| D1 | D1 / GPIO1 | GPIO | Pushbutton |
| D2 | D2 / GPIO2 | GPIO | Pushbutton |
| D38 | GPIO38 | UART | RX |
| D39 | GPIO39 | UART | TX |
| D40 | GPIO40 | PWM | |
| D43 | GPIO43 | I2C | SDA |
| D44 | GPIO44 | I2C | SCL |
| D50 | GPIO50 | SPI | MOSI |
| EN | 3.3V Regulator Enable Pin | POWER | |
| 3.3V | 3.3V Output | POWER | |
| GND | Ground | GND |
Interactive pinout
Highlight:
ESP32-S2
Click a pin to copy its name · tap a tag above to spotlight a bus.