ENC28J60

Interface — Ethernet/CAN/serial

The ENC28J60 is an Ethernet controller that supports SPI interface, designed for microcontroller-based Ethernet network interfaces.

In stock

Specifications

Pin	Name	Functions	Notes
1	VCAP	GPIO	2.5V output from internal regulator
2	VSS	GND
3	CLKOUT	GPIO	Programmable clock output pin
4	INT	GPIO	Interrupt output pin
5	NC	GND	Reserved function; always leave unconnected.
6	SO	SPI	Data out pin for SPI interface
7	SI	SPI	Data in pin for SPI interface
8	SCK	SPI	Clock in pin for SPI interface
9	CS	SPI	Chip select input pin for SPI interface
10	RESET	GPIO	Active-low device Reset input
11	VSSRX	GND
12	TPIN-	GPIO	Differential signal input
13	TPIN+	GPIO	Differential signal input
14	RBIAS	GPIO	Bias current pin for PHY. Must be tied to ground via a resistor.
15	VDDTX	POWER
16	TPOUT-	GPIO	Differential signal output
17	TPOUT+	GPIO	Differential signal output
18	VSSTX	GND
19	VDDRX	POWER
20	VDDPLL	POWER
21	VSSPLL	GND
22	VSSOSC	GND
23	OSC1	GPIO	Oscillator input
24	OSC2	GPIO	Oscillator output
25	VDDOSC	POWER
26	LEDB	GPIO	LED driver pin
27	LEDA	GPIO	LED driver pin
28	VDD	POWER

Highlight:

ENC28J60

Click a pin to copy its name · tap a tag above to spotlight a bus.